Replacement Metal Plates Set 16 Pack for Magnetic Car Phone Holders, Wall, Air Vent Mounts, Cases, Magnets. Kit of 8 Black round and 8 Rectangular Iron Discs without Holes. 3M Adhesive Backing

INSTRUCTIONS (THIS IS NOT A MAGNET! THIS IS A METAL PLATE FOR INTERACTION WITH A MAGNET OR MAGNETIC MOUNT!)

1. Clean the back of your phone, case, wall or any other flat surface from dirt, dust, human sweat with alcohol;

2. Stick the metal sticker to the flat surface and peel off the protective film from the front side of the iron plate;

3. Press the metal plate firmly against the phone so that the adhesive spreads over the entire area of the plate

4. Wait 3 to 24 hours for the adhesive on the metal phone plate to reach maximum adhesion to the flat surface.

THE WAYS TO PLACE METAL PLATES

1. Stick the thin metal plate on the back of the phone
2. Stick metal plate on the back of your phone case
3. Stick metal plate inside of the phone case

Note: Please place the adhesive metal plate away from the wireless charging area, so as not to affect the wireless charging.

IF YOUR MAGNETIC MOUNT IS WEAK OF IF THE STRENGTH OF MAGNETISM IS NOT ENOUGH - use 2 metal plates together, sticking on top of each other, getting a double steel sheet. This method will increase the thickness of the metal, which will increase the suction power of the magnet.

It's very dangerous to read messages on cell phone in one hand while driving. Using our metal plate to attach to the magnetic phone holder can let your hands free and ensure your safe driving.

The metal plates is made of high-quality manganese steel / stainless steel and has no magnetism. It's just replacements plates for magnetic phone holder.